Security, Ip protocol type filtering – Paradyne 6342 User Manual
Page 37
3. Configuring the DSL Router
6300-A2-GB20-10
November 2003
3-11
Security
The router offers security via the following:
Filtering. A filter consists of a set of rules applied to a specific interface to
indicate whether a packet received or sent on that interface is forwarded or
discarded. Filters are applied to traffic in either the inbound (from the Ethernet
port) or outbound (from the DSL port) direction on that interface:
— IP Protocol Type: TCP, UDP, or ICMP
— ICMP Message Type, Code
— TCP/UDP Ports
— Source/Destination IP Address
— Ethernet Type
Always enabled:
— Land Bug Prevention
— Smurf Attack Prevention
NOTE:
All Hotwire DSL Router filters are configured on the Hotwire DSL card. Some
routing parameters that affect filtering, such as enabling bridging or routing,
can only be configured on the DSL router.
IP Protocol Type Filtering
By default, IP Protocol Type (IP) filtering is disabled on the Hotwire DSL card for
the DSL router. If enabled, filtering provides security advantages on LANs by
restricting traffic on the network and hosts based on the source and/or destination
IP addresses.
There is one filter per direction, with a maximum of 33 rules per filter. For IP filters,
all filter access rules with a source host IP address are applied first, with all rules
with a destination host IP address applied next. The remaining filters are applied in
the order in which they were configured.
For additional information about IP filtering, refer to the
.