beautypg.com

Show interface {eth1 | dsl1, Command line interface , fo – Paradyne 6342 User Manual

Page 101

background image

A. Command Line Interface

6300-A2-GB20-10

November 2003

A-27

show interface

{eth1 | dsl1}

Minimum Access Level: Operator
Command Mode: Standard

Displays interface status for the specified interface, eth1 or dsl1, and whether the interface
is available to transport data.

eth1 – Ethernet interface status.

dsl1 – DSL interface status.

Status information displayed for show interface eth1:

Ethernet Link: {up

| down}, {available | unavailable} (This is the same

status as the Ethernet LED.)
MAC address: xx:xx:xx:xx:xx:xx

proxy ARP eth1 {enabled

| disabled}

MTU: xxxx

DSL link encapsulation last detected: {EtherHDLC

| FUNI/MPOA |

none}
ifn eth1:1

– ip-addr x.x.x.x mask x.x.x.x

1

ifn eth1:2

– ip-addr x.x.x.x mask x.x.x.x

ifn eth1:3

– ip-addr x.x.x.x mask x.x.x.x

ifn eth1:4

– ip-addr x.x.x.x mask x.x.x.x

Status information displayed for show interface dsl1:

DSL Link:

{up | down} {available | unavailable} (This is the same status as

the DSL LED.)
MAC address: xx:xx:xx:xx:xx:xx

proxy ARP dsl1 {enabled

| disabled}

ifn dsl1:1

– ip-addr x.x.x.x mask x.x.x.x

1,2

ifn dsl1:2

– ip-addr x.x.x.x mask x.x.x.x

ifn dsl1:3

– ip-addr x.x.x.x mask x.x.x.x

ifn dsl1:4

– ip-addr x.x.x.x mask x.x.x.x

1

The Primary designation of a numbered interface marks that interface as the one
whose IP address is used as a Router ID. If no interface is defined as Primary, the
last numbered interface created becomes the Primary IP Address.

2

For an unnumbered DSL interface, dsl1 unnumbered appears instead of
ifn dsl1

.

show ip route

[ip-address ]

Minimum Access Level: Operator
Command Mode: Standard

If an IP address is not provided, the entire table will be displayed with the upstream routes
displayed first and the downstream routes next. If the IP address is provided, only the
specific entry will be displayed. If the next hop IP address is 0.0.0.0, the host is directly
reachable on the Ethernet interface (eth1).

Sample show ip route display:

source ip-addr source subnet-mask nexthop ip-addr interface

x.x.x.x x.x.x.x x.x.x.x dsl1

dest ip-addr dest subnet-mask nexthop ip-addr interface

x.x.x.x x.x.x.x x.x.x.x eth1

Table A-17. Show Commands (4 of 10)

This manual is related to the following products: