Paradyne 6342 - Manual (Page 103)

A. Command Line Interface
6300-A2-GB20-10 November 2003 A-29
show pppoe
Minimum Access Level: Operator
Command Mode: Standard
Sample show pppoe display:
PPPoE {enabled | disabled}
PPPoE stage - {initial | discovery | PPP session}
PPPoE session ID - {xYYYY | none}
Peer IP address - x.x.x.x
Peer MAC address - xx:xx:xx:xx:xx:xx
IP passthrough - {enabled | disabled}
Passthrough MAC address - xx:xx:xx:xx:xx:xx
PPP session state - {initial | starting | closed | stopped |
closing |stopping | req-sent | ack-rcvd | ack-sent | opened}
Negotiated IP address - x.x.x.x,
assigned to {eth1 | dsl1} interface (in use: {eth1 |dsl1}) *
Negotiated DNS server - x.x.x.x, x.x.x.x,
no-dns [not] selected
PPP authentication - {CHAP | PAP | both | none} (in use: {CHAP |
PAP | none}) *
User name user@context (in use: user@context)*
* In use information only appears when the configured value differs from what is
actually used in the current PPP session.
show spanning-tree
Minimum Access Level: Operator
Command Mode: Standard
Displays the spanning-tree topology for the router.
Sample show spanning-tree display:
Spanning tree protocol – enabled
Bridge ID – priority 120, address 00:00:0d:00:00:00
Topology change detected/received – false
Timers (seconds): hello 2, max age 20, forward delay 15,
topology change 35, hold 1, aging 300
Root ID – priority 120, address 00:00:0d:00:00:00
Root path cost – 0
Root port ID – priority 128, number 0
Port eth1 ID – priority 128, number 1
Port eth1 state – disabled *
Port eth1 designated bridge – priority 120,
address 00:00:0d:00:00:00
Port dsl1 ID – priority 128, number 2
Port dsl1 state – disabled *
Port dsl1 designated bridge – priority 120,
address 00:00:0d:00:00:00
* Possible values for Port eth1 state and Port dsl1 state are disabled, learning,
listening, forwarding, or blocked.
Table A-17. Show Commands (6 of 10)