Paradyne 6342 - Manual (Page 122)

C. Traps and MIBs
C-8 November 2003 6300-A2-GB20-10
IP Group (RFC 1213)
The Internet Protocol Group objects are supported by the unit for all data paths
that are currently configured to carry IP data to/from the unit. All of the objects in
the IP Group, except for the IP Address Translation table, are fully supported.
Table C-5, IP Group Objects , provides clarification for objects contained in the IP
Group.
Table C-5. IP Group Objects
Object Description Setting/Contents
ipForwarding
(ip 1) Specifies whether the unit is
acting as an IP gateway for
forwarding of datagram
received by, but not addressed
to, the DSL router. The value is read-only and always displays: (1)
ipDefaultTTL
(ip 2) TTL = Time To Live. Minimum value is 15. Maximum value is 255.
„ The default is 64.
ipAddrTable
(ip 20) The address table. The device sets the object ipAdEntReasmMaxSixe
to 16384. Supported as read-only.
ipNetToMediaTable
(ip 22) This table allows access to
contents of the ARP cache. This table is implemented with read/write access.
ipNetToMediaType
(ipNetToMediaEntry 4) Supported for ARP table
entries. „ other(1) – Entry is incomplete.
„ invalid(2) – Invalidates corresponding entry in the
ipNetToMediaTable.
„ dynamic(3) – Results in a response with a badValue
error status. Dynamic ARP table entries will still display
with the correct dynamic (3) value, but a Set is not
allowed.
„ static(4)