beautypg.com

Dial access security messages – Paradyne 3810 User Manual

Page 39

background image

COMSPHERE 3800 Series Modems

4-12

November 1996

3810-A2-GB30-20

Messages listed in Table 4-6 are dial access security

messages that can occur when the optional security
feature is installed.

The Top-Level menu’s main branches appear on the

LCD in the order of Call Setup, Talk / Data, Status, Test,
Configure, Control, Security, and Remote. These branches
are described in the following chapters.

Table 4-6

Dial Access Security Messages

Dial Access

Security

Messages

Indicates

Get VF PsWd

The answering modem is waiting for the originating caller to transmit a VF password.

Get DTE PsWd

The answering modem is waiting to receive a valid DTE password from the remote DTE.

VF PsWd Timeout

The modem did not finish answering a call (disconnected) because the allowed time limit was
exceeded before the modem received a VF password from the originating dialer.

Unknown DTEpswd

The modem did not finish answering a call (disconnected) because the DTE passwords received
from the remote DTE were invalid.

No Orig PsWd

The modem did not attempt to establish a call as requested because the AT dial command did not
contain an originate access password.

Unknown VF PsWd

The modem did not finish answering a call (disconnected) because the modem received an
invalid VF password.

DTEpswd Timeout

The modem did not finish answering a call (disconnected) because the allowed time limit was
exceeded before the modem received a DTE password from the remote DTE.

Inval Orig PsWd

The modem did not attempt to establish the call as requested because the originate password in
the AT dial command was not valid.

DTR Dial Blocked

Appears if DTR dialing is used and Answer Access or Originate Access security is enabled. DTR
dialing is not permitted when security is enabled.

SecurityBlocked

Appears only when the modem is in base mode (a mode that occurs during a firmware download)
and Answer Access Security is enabled. In this case, the access verification capabilities are not
available and the modem does not pass data to the DTE under any circumstances.