Paradyne 3810 - Manual (Page 143)

AT Command Set and S-Registers
14-9 3810-A2-GB30-20 November 1996
Table 14-1
(7 of 12)
3800 Series AT Commands
AT
Command
Front Panel
Branch
Description
& I Dial Transmit Level
When Dial Transmit Level Type is set to Permissive, & In sets Dial Transmit
Level to a value between –10 and –32 dBm. & I 99 and & I 100 cause the level to
be varied automatically according to conditions for Enhanced Throughput
Cellular (ETC) operation.
& I 10 –10 dBm
& I 11 –11 dBm
S S
S S
& I 32 –32 dBm
& I 99 Automatically adjusted according to the ETC1.0 specification . Use only
with remote modems set to & I 99, and limit the data rate to 4800 bps
(S41 = 5). Set by &F6.
& I 100 Automatically adjusted according to the ETC1.1 specification.
NOTE: &J0 overrides this command; & I n overrides the &J0 command.
Configure\Edit\Dial Line
&J n Dial Transmit Level Type
&J0 Permissive (Approx. – 9 dBm).
&J1 Programmable
NOTE: &J n overrides the & I n command.
Configure\Edit\Dial Line
&L n Leased Mode
&L0 Disables leased-line operation.
&L1 2-wire originate leased-line operation.
&L2 4-wire originate leased-line operation (Model 3810 and 3811 only).
&L3 2-wire answer leased-line operation.
&L4 4-wire answer leased-line operation (Model 3810 and 3811 only).
The &L command will cause the modem to reset before entering or exiting
Leased-Line mode. Therefore, it must be entered as the last command in an
initialization string.
Configure\Edit\Leased
Line