Paradyne 3810 - Manual (Page 37)

COMSPHERE 3800 Series Modems
4-10 November 1996 3810-A2-GB30-20
Table 4-4
(3 of 3)
Top-Level Menu Status
Dial Backup
Messages
Indicates
Dial Standby The modem is operating in Dial Standby mode.
DialBckUp: MR* The modem is operating in a Dial Backup mode at the displayed data rate and is configured for
Direct mode.
Backup: MR* EC** The modem is operating in Dial Backup mode and is configured for error control and data
compression on leased lines.
Stndby: MR* EC** The modem is operating in Dial Standby mode and is configured for error control and data
compression on leased lines.
Firmware
Download Result
Messages
Indicates
DownldOnly Mode Indicates that a local download of firmware or a remote cloning of firmware has failed. The
modem is currently in a Download Only mode in which only another download attempt is possible.
Frmware Upgrade Indicates that a local download of firmware or a remote cloning of firmware was successful.
RemClone Failed Displays on the local modem’s LCD and indicates that a remote cloning of firmware has failed.
Remote Clone OK Displays on the local modem’s LCD and indicates that a remote cloning of firmware was
successful.
AT Command
Reset Message
Indicates
Reset by AT
command The modem has performed a reset in response to an ATZ command.
* MR. Modem Rate indicates the data rate the modem is using. One of the following values appears: 300, 1200, 2400,
4800, 7200, 9600, 12K (12,000), 14.4 (14,400), 16.8 (16,800), or 19.2 (19,200) bps.
** EC. Error Control indicates the modem is online and using V.42 or MNP error control. One of the following values
appears after the modem rates listed above: MNP2, MNP3, MNP4, MNP5, V42, V42b, or NoEC. (NoEC indicates the
modem is connected in Buffer mode rather than error control. If an EC value does not appear, then the modem is in
Direct mode.)