Remote branch – Paradyne 3810 User Manual

Page 117

COMSPHERE 3800 Series Modems

11-2

November 1996

3810-A2-GB30-20

Remote Branch

The following conditions must be met before using the

Remote branch:

•

A connection using either the dial network or leased
lines must be established.

•

The Access from Remote configuration option must
be enabled in the remote modem.

•

The Remote Access Password configuration option
must be the same for both the local and remote
modems.

Remote DCP access is accomplished using either the

primary or secondary channel (if available) of the VF line.
Using the primary channel gives a much faster response
time due to the higher data rate, but it also interrupts data
flow because primary data is stopped when Remote mode
is active. Once Remote mode is terminated, the primary
channel is automatically made available to data
transmission.

Unlike primary channel communications, the

secondary channel operates at a slower data rate and does
not interrupt data flow. (V.32bis and V.32 are the only
modulations available on the secondary channel.)

To access the Remote branch, make the following

selections:

Online : 19.2

Control Remote

Press the

key until Remote appears. Select

Remote.

NOTE

If a connection is not established
between a local 3800 Series
modem and a remote 3800 Series
modem, the LCD displays
Remote Mode Fail – No Circuit.
Press the key to return to the
Top-Level menu and dial again.

Select Channel

Secondary

Select Channel

Prim (data blckd)

If operation over the secondary channel is desired,

press any function key to select the secondary channel.
Secondary channel only appears if using V.32bis or
V.32 modulation. If operation over the primary channel is
desired, press the

key until Prim appears, and press

any function key.