Paradyne 3810 User Manual
Page 147
AT Command Set and S-Registers
14-13
3810-A2-GB30-20
November 1996
Table 14-1
(11 of 12)
3800 Series AT Commands
AT
Command
Front Panel
Branch
Description
\Q
n
Flow Control of DTE, Flow Control of Modem
Flow
Flow
Control
Control of
of DTE
Modem
\Q0
Disable
Disable
\Q1
XON/XOFF
XON/XOFF
\Q2
CTS to DTE
Disable
\Q3
CTS to DTE
RTS to Mdm
\Q4
XON/XOFF
Disable
\Q5
Disable
XON/XOFF
\Q6
Disable
RTS to Mdm
Configure\Edit\
V42/MNP/Buffer
\T
n
No Data Disconnect Timer
\T0
Disable.
\T
n
Where
n is a value from 1 to 255 in 1-minute increments.
Configure\Edit\Line
Dialer
\X
n
XON/XOFF Passthrough Flow Control
\X0
Disable.
\X1 Enable.
Configure\Edit\
V42/MNP/Buffer
%A
n
Error Control Fallback Character
%A
n Where n is an ASCII value from 0 to 127. Factory default is 013 ASCII.
Configure\Edit\
V42/MNP/Buffer
%B
n
Modulation and Data Rate
Sets the modulation and maximum VF rate.
The %B300 and %B1200 commands work in conjunction with the B (CCITT/
Bell Mode) command to determine modulation.
%B19200
V.32
terbo, maximum rate 19,200 bps
%B16800
V.32
terbo, maximum rate 16,800 bps
%B14400
V.32bis, maximum rate 14,400 bps
%B12000
V.32bis, maximum rate 12,000 bps
%B9600
V.32bis/V.32, maximum rate 9600 bps
%B7200
V.32bis, maximum rate 7200 bps
%B4800
V.32bis/V.32, maximum rate 4800 bps
%B2400
V.22bis. maximum rate 2400 bps
%B1200
V.22 or Bell 212A, maximum rate 1200 bps
%B300
V.21 or Bell 103, maximum rate 300 bps