Paradyne 3810 User Manual
Page 140
COMSPHERE 3800 Series Modems
14-6
November 1996
3810-A2-GB30-20
Table 14-1
(4 of 12)
3800 Series AT Commands
AT
Command
Front Panel
Branch
Description
V
n
Result Code Format
V0
Displays result codes in Number (1) format digits.
V1
Displays result codes as text.
V2
Displays result codes in Number (2) format (digits).
Configure\Edit\DTE
Dialer
X
n
Extended Result Code, Dial Tone Detect, and Busy Tone Detect
Configuration Options
Ext Dial Tone Busy Tone
Result Code Detect Detect
X0
Disable
Disable
Disable
X1
Enable
Disable
Disable
X2
Enable Enable
Disable
X3
Enable
Disable
Enable
X4
Enable Enable
Enable
X5
Add/EC
Enable
Enable
X6
Add/V42,MNP
Enable
Enable
X7
Use DTE Rate
Enable
Enable
Extended Result Code:
Configure\Edit\DTE
Dialer
Dial Tone Detect:
Configure\Edit\Line
Dialer
Busy Tone Detect:
Configure\Edit\Line
Dialer
X7
Use DTE Rate
Enable
Enable
EXTENDED RESULT CODE
Enable. Displays all result codes listed in Table B-1 except for error control
suffix.
Disable. Only displays OK, CONNECT, RING, NO CARRIER, ERROR.
Add/EC. Displays result codes with /EC suffix. Add/V42,MNP. Displays result
codes with either V.42 or MNP suffix. Use DTE Rate. Displays DTE data rate
instead of line rate.
Add/V42,MNP. Displays result codes with either V.42 or MNP suffix.
Use DTE Rate. Displays DTE data rate instead of line rate.
DIAL TONE DETECT
Enable. Sets the modem for dial tone detect.
Disable. Sets the modem for blind dialing.
BUSY TONE DETECT
Enable. Modem monitors for busy tone.
Disable. Modem ignores busy tone.
Y
n
Long Space Disconnect
Y0
Disable. Ignores long space.
Y1
Enable. Disconnects if long space is detected. Enables transmission of a
long space.
Configure\Edit\Line
Dialer
Z
n
Reset and Load Active
Z0
Loads configuration options from Active (Saved) to Active (Operating).
Z1
Loads configuration options from Customer 1 to Active (Operating).
Z2
Loads configuration from Customer 2 to Active (Operating).
Z3
Loads configuration options from Active (Saved) to Active (Operating)
and performs a “soft” reset (if the modem is connected, it is
disconnected).
Z9
Performs a full modem reset, as if the power were turned off and on.
Control\Reset