System group, System group objects – Paradyne 7612 SNMP DSU User Manual
Page 88
MIB Descriptions
C-2
7612-A2-GB20-10
November 1997
— DDS network interface using the DDS Enterprise MIB.
— User Data (DTE) port and Terminal port using the RS-232-like MIB.
— 10BaseT port using the Ethernet-like MIB.
The following MIB II groups are not supported:
H
Address Translation Group
H
Exterior Gateway Protocol ( EGP ) Group
System Group
System Group objects are fully supported by the unit, as shown in
Table C-1.
System Group Objects
Object
Description
Setting/Contents
sysDescr
( system 1)
Provides a full name and version
identification for the system’s
hardware and software.
PARADYNE DDS Leased Line DSU
;
Model: 7612-A1-201;
S/W Release:
yy.yy.yy;
H/W Revision:
zzzz-zzz;
Serial Number:
sssssss
sysObjectID
( system 2)
Identifies the network
management subsystem.
1.3.6.1.4.1.1795.1.14.2.5.1.1
sysContact
(system 4)
Provides the textual identification
of the contact person for this
managed unit.
1
ASCII character string, as set by the
user.
sysName
(system 5)
Provides an administrative
assigned name for this managed
unit.
1
ASCII character string, as set by the
user.
sysLocation
(system 6)
Provides the physical location for
this managed unit.
1
ASCII character string, as set by the
user.
sysServices
( system 7)
Functionality supported:
H
physical (1 ) – Layer 1
functionality for all interfaces.
H
datalink/subnetwork ( 2 ) –
Layer 2 functionality ( PPP ) for
all management links.
H
internet ( 4 ) – Layer 3
functionality ( IP ) for all
management links.
H
end-to-end ( 8 ) – Layer 4
functionality ( TCP/ UDP ) for all
management links.
Object is set to 1+2+4+8 (15).
1
The unit supports a 127-character string for this object. An error message is sent to
the NMS if an attempt is made to write (set) more than 127 characters.