Paradyne 7612 SNMP DSU - Manual (Page 29)

Security
4-2 7612-A2-GB20-10 November 1997
Creating a Login
Logins apply to Terminal port access and Telnet access to the ATI. Six login
ID/password combinations are available. Each Login ID and Password must be
unique and include an access level.
For additional information regarding the ATI access using the Login Required
option, refer to
ATI Access on page 4-3 .
"
Procedure
To create a login record:
1. Follow this menu selection sequence:
Main Menu
→
Control
→
Administer Logins
2. Press Ctrl-a to switch to the screen function key area below the dotted line.
3. Select New and press Return.
4. Create the login by entering the following fields.
On the Administer
Logins screen, for the . . . Enter . . .
Login ID 1 to 10 ASCII printable characters
Password 1 to 10 ASCII printable characters
Access Level Level 1, Level 2, or Level 3
NOTE:
Assign at least one Level 1 Access Level. Full access is necessary to
make configuration option changes and administer logins. If there is no
effective Access Level 1, refer to
Device Reset in Chapter 7, Testing .
5. Press Ctrl-a to switch to the screen function key area below the dotted line.
Select Save and press Return.
6. When Save is complete, Command Complete appears at the bottom of the
screen. Select:
— New to add another login record
— MainMenu to go to the Main Menu
— Exit to end the ATI session