Paradyne 7612 SNMP DSU User Manual
Page 84
Worksheets
B-2
7612-A2-GB20-10
November 1997
Network Interface
Configuration Option
Settings
Default in [Bold]
Network-initiated DSU Loopback (64K CC)
[Enable], Disable
Data Scrambling (64K CC)
Enable, [Disable]
V.54 Initiated DSU Loopback
Enable, [Disable]
In-Band Management Channel Rate (bps)
[Disable], 1600, 4000, 8000
IMC IP Address
[000.000.000.000] – 223.255.255.255
IMC Subnet Mask
[000.000.000.000] – 255.255.255.255
IMC Routing Information Protocol
None, [Proprietary]
Data Port
Configuration Option
Settings
Default in [Bold]
Invert Transmit Clock
Enable, [Disable]
Port (DTE) Initiated Loopbacks
[Disable], Local, Remote, Both
Bilateral Loopback
Enable, [Disable]
Carrier Control by RTS
[Constant], Switched
CTS Control
[Standard], Follow RTS, Forced On,
Circuit Assurance
RLSD Control
[Standard], Forced On
DSR Control
[Standard], Forced On, On During Test
Monitor DTR
[Enable], Disable
Ethernet Port
Configuration Option
Settings
Default in [Bold]
Port Use
802.3, Version 2, Disable
IP Address
[000.000.000.000] – 223.255.255.255
IP Subnet Mask
[000.000.000.000] – 255.255.255.255
Default Gateway Address
[000.000.000.000] – 223.255.255.255