Paradyne 7612 SNMP DSU - Manual (Page 66)

Configuration Option Tables
A-2 7612-A2-GB20-10 November 1997
Select . . . To Access the . . . To Configure the . . .
System System Options , Table A-1 General system
options.
Network Network Interface Options , Table A-2 DDS network interface.
Data Port Data Port Options , Table A-3 DTE port.
Ethernet Port Ethernet Port Options , Table A-4 10BaseT port.
Terminal Port Terminal Port Options , Table A-5 Terminal port.
Telnet Session Telnet Session Options , Table A-6 Telnet user interface.
SNMP H General SNMP Management Options ,
Table A-7
H SNMP NMS Security Options , Table A-8
H SNMP Traps Options , Table A-9
Management support
through SNMP.
All changes to configuration options must be saved. Refer to Saving
Configuration Options in Chapter 3, Configuring the DSU .
System Options Menu
For System Options, refer to Table A-1. To access the System Options screen,
follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Edit
→
System
Table A-1. System Options (1 of 3)
Operating Mode
Possible Settings: DDS, LADS
Default Setting: DDS
The unit’s operating mode depends upon the DSU’s application.
DDS – Standard DDS network operation. The operating rate is either 56 kbps or
64 kbps CC.
LADS – The Local Area Data Set operating mode requires that the local and remote
units are connected directly to each other. This is a point-to-point application; also
known as LDM.