Paradyne 7612 SNMP DSU - Manual (Page 47)

Monitoring the DSU
6-10 7612-A2-GB20-10 November 1997
Network Interface Status
To view the Network Interface Status, follow this menu selection sequence:
Main Menu
→
Status
→
Network Interface Status
О
О
ОО
ОО
main/status/interface
Device Name: Node A Model: 7612
NETWORK INTERFACE STATUS
Line Rate (Kbps): 64CC
Loop Loss (dB): –25
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
ESC for previous menu MainMenu Exit
Refresh
Table 6-4 describes the fields on the Network Interface Status screen.
Table 6-4. Network Interface Status Screen Contents
Field Status What the Status Indicates
Line Rate (Kbps) 56
64CC
64LADS Line rate on the network interface.
Autobaud indicates the DSU is
trying to determine the network line
64LADS
Autobaud trying to determine the network line
rate. If this does not change to a
numeric value within about
25 seconds, you may need to set
the Line Rate manually
No Signal
the Line Rate manually.
No signal can be detected over the
network interface.
Loop Loss (dB) 0 to – 65 Amount of loop loss – loss of signal
strength of the receive line signal
from the local loop, measured in
decibels.
Inoperative The line may be disconnected.