Lexmark 5300 Series - Manual (Page 122)

D
ISCONNECT AND RECONNECT THE POWER CORD
1 Disconnect the power cord from the wall outlet, and then from the printer.
2 Plug the cord all the way into the power supply on the printer.
3 Plug the cord into an electrical outlet that other electrical devices have been using.
4 If the light is not on, press .
Software does not install
These are possible solutions. Try one or more of the following:
C
HECK YOUR OPERATING SYSTEM
The following operating systems are supported: Windows Vista, Windows XP, Windows 2000 with Service Pack 3
or later, and Mac OS X.
C
HECK YOUR SYSTEM REQUIREMENTS
Check that your computer meets the minimum system requirements listed on the printer box.
C
HECK
USB
CONNECTION
If the printer is connected to the computer through a USB cable:
1 Check the USB cable for any obvious damage.
2 Firmly plug the square end of the USB cable into the back of the printer.
3 Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with the USB symbol.
C
HECK WIRELESS CONNECTION
If the printer supports networking, and you are using the printer on a wireless network, check to see if the Wi-Fi
indicator light is on.
R
ECONNECT POWER SUPPLY
1 Press to turn the printer off.
2 Disconnect the power cord from the wall outlet.
3 Gently remove the power supply from the printer.
Troubleshooting
122