Lightwave Communications LDX-3232 - Manual (Page 79)

C O M M A N D R E F E R E N C E
LDX-3232 Device-Dependent Command Reference
04_06 LDX-3232 63
C H A P T E R
4
The LASer:LDV command sets the laser voltage for calibration of the laser voltage
measurement.
Syntax Diagram
Parameters An that represents the (laser) output voltage, in volts.
Notes setpoint is the same for both low and high bandwidth output modes and is entered only
for LDV calibration.
Examples "Las:LDV 4" -action: enters a value of 4.000 V.
"LAS:ldv 1.025" -action: enters a value of 1.025 V.
The LASer:LDV? query returns the value of the measured laser voltage.
Syntax Diagram
- where the response is the measured laser output voltage for either low or high
bandwidth modes.
Notes This measurement is updated approximately once every 600 ms.
Examples "LAS:ldv?" -response: 3.03, means the measured laser output voltage is 3.03 V.
"Laser:LDV?" -response: 1.0, means the measured laser output voltage is 1.000 V.
LASer:LDV F RONT P ANEL
R EMOTE
LASer:LDV? F RONT P ANEL
R EMOTE
space> value>
: : LAS LDV
:
LAS :
LDV ?