Lightwave Communications LDX-3232 - Manual (Page 51)

C O M M A N D R E F E R E N C E
04_06 LDX-3232 35
C H A P T E R
4
C H A P T E R
4
C
OMMAND
R
EFERENCE
This chapter is a guide to all of the device-dependent commands for the
LDX-3232 High Compliance Current Source. This chapter is divided into two
parts. The first part contains an overview of the remote commands used by the
LDX-3232 High Compliance Current Source. The second part contains all of the
LDX-3232 commands in alphabetical order. Figure 4.1 shows the format for the
device command descriptions in this chapter. The commands that emulate local
(front panel) operation are denoted by the solid box next to the Local label in the
upper left corner of the command description.
Table 4.1 LDX-3232 Series Device-Dependent Commands
Name Parameters Function
DELAY 1 Used to create a delay in the execution of further
commands
ERR? NONE Returns errors generated since the last query
LAS:CALMD 1 Used to set the CAL PD (monitor responsivity) constant
LAS:CALMD? NONE Returns the CAL PD (monitor responsivity) constant
LAS:CAL:CONST? 1 Factory use only
LAS:CAL:LDI NONE Used to enter the laser current calibration mode
LAS:CAL:LDI? NONE Returns the ready state for entering the laser current
calibration value
LAS:CAL:LDV NONE Used to enter the laser voltage calibration mode
LAS:CAL:LDV? NONE Returns the ready state for entering the laser voltage
calibration mode
LAS:CAL:MDI NONE Used to enter the monitor photodiode current calibration
mode