Lightwave Communications LDX-3232 - Manual (Page 69)

C O M M A N D R E F E R E N C E
LDX-3232 Device-Dependent Command Reference
04_06 LDX-3232 53
C H A P T E R
4
The LASer:DISplay:PARAM command enables the display to show the parameter
values.
Syntax Diagram
Parameters None
Notes This command has the same effect as pressing the (PARAMETER) SELECT switch
while in LASER mode. The selected parameter will be displayed for three seconds. The
actual LASER PARAM display is turned off automatically when a display selection is
enabled.
Each time the command is issued, the next LASER parameter will be selected, see
Chapter 2 for more information.
Examples "Laser:Display:Param" -action: selects a parameter and displays its value.
"LAS:DIS:PARAM" -action: selects a parameter and displays its value.
The LASer:DISplay:SET command sets the display to show the setpoint of the selected
display mode.
Syntax Diagram
Parameters None
Notes Using this command has the same effect as physically holding the (DISPLAY) SELECT
switch down continuously.
Examples "Las:Dis:Set" -action: enables the display for the setpoint of the selected mode: LDI,
MDI (I
PD
) or MDP (P
PD
)
"LAS:Dis:Set" -action: enables the display for the setpoint of the selected display mode.
LASer:DISplay:PARAM F RONT P ANEL
R EMOTE
LASer:DISplay:SET F RONT P ANEL
R EMOTE
: LAS : : DIS PARAM
: LAS : : DIS SET