Lightwave Communications LDX-3232 - Manual (Page 76)

C O M M A N D R E F E R E N C E
LDX-3232 Device-Dependent Command Reference
60 LDX-3232
C H A P T E R
4
The LASer:EVEnt? query returns the value of the status event register of the LASER
operations.
Syntax Diagram
-where the response is the sum of the following:
Notes The LASER conditions that are reported in the status byte can be set by using the
LASer:ENABle:EVEnt command.
The LASER event status is only cleared when the event status is read or by the *CLS
command while the condition status is constantly changing.
Examples "LAS:EVE?" -response: 513, means that the LASER output tolerance changed and
current limit events have occurred since the last LASer:EVEnt? query.
"Radix Hex; Laser:Event?" -response: #H88, means that the LASER Power limit and
Open circuit events have occurred since the last LASer:EVEnt? query.
LASer:EVEnt? F RONT P ANEL
R EMOTE
1 LASER Current Limit 256 Output is shorted
2 LASER Voltage Limit 512 Output changed to be in/out of tolerance
4 N/A 1024 Output on/off state changed
8 Power limit 2048 Measurement ready
16 Interlock disabled 4096 N/A
32 N/A 8192 N/A
64 Compliance Voltage Limit 16384 N/A
128 Open circuit 32768 N/A
:
LAS EVE : ?