Lightwave Communications LDX-3232 - Manual (Page 68)

C O M M A N D R E F E R E N C E
LDX-3232 Device-Dependent Command Reference
52 LDX-3232
C H A P T E R
4
The LASer:DISplay:MDP command sets the display to show the monitor photodiode
power measurement.
Syntax Diagram
Parameters None
Notes The MDP measurement display is turned off automatically when another display
selection is enabled.
Examples "Las:Display:MDp" -action: enables the display for photodiode power measurement
values.
"Laser:Disp:MDP" -action: enables the display for photodiode power measurement
values.
The LASer:DISplay:MDP? query returns the status of the MDP (monitor diode power)
measurement display mode.
Syntax Diagram
- where the response is 0 or 1.
Notes In local operation, the status of the MDP measurement mode is indicated by the
enunciator next to the display (mW will be illuminated and not blinking when the display
is in MDP measurement mode).
Examples "LAS:DISp:MDp?" -response: 0, means that the MDP measurement is not displayed.
"Las:dis:MDP?" -response: 1, means that the MDP measurement is displayed.
LASer:DISplay:MDP F RONT P ANEL
R EMOTE
LASer:DISplay:MDP? F RONT P ANEL
R EMOTE
:
LAS : : DIS
PPD
MDP
: LAS : DIS
PPD
: ?
MDP