Lightwave Communications LDX-3232 - Manual (Page 72)

C O M M A N D R E F E R E N C E
LDX-3232 Device-Dependent Command Reference
56 LDX-3232
C H A P T E R
4
The LASer:ENABle:EVEnt command sets the status event enable register of the LASER
operations. These events are summarized in bit 2 of the status byte register.
Syntax Diagram
Parameters An whose sum represents the bits that are enabled:
Notes The enabled LASER events can be read by using the LASer:ENABle:EVEnt? query. The
LASER event status can be monitored by the LASer:EVEnt? query.
The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition, in the GPIB-IEEE488 specification).
Examples "LAS:ENAB:EVENT 136" -action: enables the LASER status event register so that the
Open circuit and Power limit events will be reported (in summarized form) to the status
byte (bit 2).
"Laser:Enable:Event #H0F9B" -action: enables the LASER status event register so all of
the above events will be reported (in summarized form) to the status byte (bit 2).
LASer:ENABle:EVEnt F RONT P ANEL
R EMOTE
1 LASER Current Limit 256 Output is shorted
2 LASER Voltage Limit 512 Output changed to be in/out of tolerance
4 N/A 1024 Output on/off state changed
8 Power limit 2048 New measurements taken
16 Interlock changed state 4096 N/A
32 N/A 8192 N/A
64 Compliance Voltage Limit 16384 N/A
128 Open circuit 32768 N/A
:
LAS
space> value>
: ENAB : EVE