Lightwave Communications LDX-3232 - Manual (Page 73)

C O M M A N D R E F E R E N C E
LDX-3232 Device-Dependent Command Reference
04_06 LDX-3232 57
C H A P T E R
4
The LASer:ENABle:EVEnt? query returns the value of the status event enable register of
the LASER operations.
Syntax Diagram
- where the response is the sum of the following:
Notes The enabled LASER events can be set by using the LASer:ENABle:EVEnt command.
The LASER event status can be monitored by the LASer:EVEnt? query.
Examples "LAS:ENAB:EVE?" -response: 1040, means that the Output on/off state change and
Interlock changed LASER events will be reported (in summarized form) to the status byte
register (bit 2).
"Radix Hex; Las:Enab:Eve?" -response: #HFDB, means that all of the above events will
be reported (in summarized form) to the status byte register (bit 2).
LASer:ENABle:EVEnt? F RONT P ANEL
R EMOTE
1 LASER Current Limit 256 Output is shorted
2 LASER Voltage Limit 512 Output changed to be in/out of tolerance
4 N/A 1024 Output on/off state
8 Power limit 2048 New measurements taken
16 Interlock state changed 4096 N/A
32 N/A 8192 N/A
64 Compliance Voltage Limit 16384 N/A
128 Open circuit 32768 N/A
: LAS : ENAB EVE
:
?