Konica Minolta bizhub 750 - Manual (Page 476)

Utility 12
bizhub 750/600 12-63
Utility
Ch
ap
te
r 12
13
Repeat steps 7 through 11 until the desired print results are achieved.
14
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
2
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm
When PK-505 and ZU-602 are installed, adjustments can be made using
both the “Punch Adjustment” and “Z-Fold Position Adjustment” param-
eters. Contact your technical representative.
Adjusting the Z-Fold Positions
The first and second folding positions for Z-Fold can be adjusted.
0 Use the “Z-Fold” function to print a single sample copy, and then perform
the adjustment while checking the sample that was created.
When making adjustments to settings for both the “1st Z-Folded Posi-
tion” and “2nd Z-Folded Position”, be sure to first adjust the setting for
the “1st Z-Folded Position”.
0 The Z-fold position can be adjusted only when optional Z-folding unit ZU-
602 is installed.
1
Display the Administrator Setting screen.
2
Touch [1 System Setting].
The System Setting screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [4 Z-Fold Position Adjustment].
The Z-Fold Position Adjustment screen appears.