Konica Minolta bizhub 750 - Manual (Page 225)

5 Troubleshooting
5-14 bizhub 750/600
T
roubleshooting
Chap
ter 5
Finisher
If any message other than those listed above appears, perform the operation
described in the message.
If the problem is not corrected after the described operation is performed,
contact your technical representative.
Symptom Possible Cause Remedy
The finisher cannot be
used. Is there a paper misfeed in
the finisher? If there is a paper misfeed, clear it.
Is the finisher door fully
closed? Securely close the finisher door.
The pages cannot be
stapled. Have the staples run out? Replace the staple cartridge. (See
p. 9-7.)
The staple is incorrectly
positioned by 90 de-
grees. Are the staples positioned as
specified? Select the desired position for the
staples. (See p. 3-59.)
The pages that were fed
out were not uniformly
loaded and the punched
holes or staples are in-
correctly positioned. Is the paper curled? Remove the paper from the paper
tray, turn it over, and then load it
again.
Is there a gap between the
lateral guides in the paper
tray and the side of the pa-
per? Slide the lateral guides in the paper
tray against the side of the paper so
that there is no gap.
Even though a Punch
setting was selected,
holes are not punched.
(when PK-505/ZU-602 is
installed on FS-504/FS-
602) Did the message “Remove
Punch Scraps.” appear? Empty the punch dust box