Konica Minolta bizhub 750 - Manual (Page 256)

Copy Paper/Original 7
bizhub 750/600 7-19
Copy Paper/Original
Chapter 7
6
Specify the length (X) and width (Y) of the paper, and then touch [OK].
– Touch [X] or [Y], touch [
↔] to switch between the integer and the
fraction, and then touch [–] and [+] to specify the size of the paper.
– If a decimal value is displayed in the screen, use the keypad to type
in the setting. For details on switching between decimal and frac-
tion values, refer to “System Setting” on page 12-14.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message “Input Error” appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
7
Touch [OK] four times.
The Basic screen appears again.
2
Note
The selected size button is programmed with the entered paper size, so
that the paper size is available to be selected again without having to be
typed in. In addition, the size can be changed.