Kodak 7520 - Manual (Page 92)

A-61140 January 2000 8-17
Using the Display
option The Display option allows you to display the decoded value of an individual
bar code as it is fed into the transport.
To verify that a bar code is decoded properly:
1. Select 2: DP.
BC Type =
1: EV 2: DP 3: Rr
2. Feed a bar code document into the transport.
One of the following messages will be displayed:
Message 1
BC Type =
?
Bar code was not read.
If the display indicates the bar code was not read, it could be for one
of the following reasons:
•
The type of bar code read was not the type indicated in the
status display.
Action: Verify the type of bar code read.
•
The bar code was fed in the wrong direction or upside down.
Action: Verify that the bar code was fed correctly.
•
The bar code quality is poor.
Action: Perform the required maintenance.
Message 2
BC Type =
*XXXXXXXXXXXXX
This display gives the decoded value of the bar code read (including
the *, representing the start character) is equal to or less than 15.