Kodak 7520 - Manual (Page 100)

8-26 A-61140 January 2000
Changing the
horizontal read
position The horizontal read position is set by placing the Patch Reader in one of
the five reader positions on the mounting plate.
NOTE: The five Patch Reader positions are also indicated with a patch
mark on the label on the feed tray.
The Patch Reader is attached to the mounting plate by magnets.
To change the position of the Patch Reader:
1. Lift the Patch Reader off the mounting plate and place it in one of the
other four available positions.
2. Perform the Patch Test function (F55) to make sure the patches
printed on the documents are aligned with the new reader position.
NOTE: The Patch Reader must be removed from the mounting plate
when raising the horizontal transport plate during vacuuming
or clearing document jams.
CAUTION: Open and close the doors slowly.
Cleaning the Patch
Reader The Patch Reader requires very little maintenance. Periodically wipe to
sensor head with a dry, lint-free cloth.
IMPORTANT: Do not remove the cable tie from the Patch Reader.
Sensor Head