Kodak 7520 - Manual (Page 106)

8-32 A-61140 January 2000
Function codes The following function codes are available if the Document Printer has
been installed and the current application mode allows you to use it.
F40 allows you to enable/disable both the front and rear Document
Printers.
F41 allows you to enable/disable the front Document Printer.
F42 allows you to enable/disable the rear Document Printer.
F44 inhibits printing on the next document entering the feeder. This
applies to both the front and rear Document Printers.
NOTE: The function codes listed above can be enabled by pressing 1; or
disabled by pressing 0.
F45 allows you run a print test by verifying the operation, vertical start
print position, and print quality.
F46 allows you to change the vertical start print position of the front
Document Printer.
F47 allows you to change the vertical start print position of the rear
Document Printer.
Using the Print
Test function Function code F45 can be used to run a print test. A print test can verify
the operation, vertical start print position, and print quality of the front and
rear Document Printers. No other accessories can be enabled during
this test. In addition, scanning, image address incrementing, document
counting, etc. will not occur during this test.
To perform a print test:
1. Enter function code F45.
2. Press Enter. A message will be displayed indicating that a print test
is being performed.
3. Feed as many documents as needed to verify the operation, position
and print quality of the information printed.
4. Press Stop when finished.