Kodak A-41069 - Manual (Page 94)

8 - 3 A-41069 January 1993
4. Remove dust from the imaging guides, using a soft bristle brush.
5. Remove fingerprints or smudges from the imaging guides, wiping
both sides of each imaging guide with a clean, soft, dry, lint-free
cloth slightly moistened with water or lens cleaner. Then, lightly
wipe both sides of each imaging guide with a dry cloth or an
antistatic wipe.
6. Remove the upper lamp housing assembly.
7. Remove dust from the upper lamp housing assembly, using a soft
bristle brush.
8. Reinstall the upper lamp housing assembly.
Repeat steps 6 - 8 for the lower lamp housing assembly.
9. Grasp and hold the lower imaging guide by the edges and carefully
slide it back into place. Make sure the grooves fully engage the
track.
10. Grasp and hold the upper imaging guide by the edges and carefully
slide it back into place. Make sure the grooves fully engage the
track.
NOTE: The imaging guides are not interchangeable. They can only be
inserted one way. Use the illustration to the left to assist you in
properly positoning the imaging guides.
11. Close the right-side access door.