Kodak A-41069 - Manual (Page 78)

A-41069 January 1993 6-5
Code Operator Message Displayed Description/Action Required
E230 Open access door to correct error Open the access door.
Verify that all operator accessible areas are
properly closed.
Press the Run key to continue.
E231 Press JOG, and try again Press the Jog key. Press the Run key. Try again.
E232 Close all access doors and RUN Close all access doors.
Press the Run key to continue.
E234 Press JOG, and try again Press the Jog key. Press the Run key. Try again.
E235 Turn main power OFF and ON Turn the side panel switch off.
E236 Turn the main power switch off.
Wait five (5) to ten (10) seconds.
Turn the main power switch on.
Turn the side panel switch on.
If the error repeats, call service.
E238 User function string invalid The P-Key, End-of-Batch, etc. definition made
during installation is invalid. Correct the definition
using the Mode Setup Software.
E240 Enter correct level of IA - refeed Set or change the document image level or use the
E241 Next key to enter a new Image Address.
E242 Press the Run key to continue.
E243
E244
E245
E246 Conflicting input - what level? Set or change the document image level to
confirm the proper document image level.
Press the Run key to continue.
E267 Clear error, re-enter IA Press the Clear key.
Use the NEXT key to enter an Image Address.
Press the Run key to continue.
E280 Feeder off due to host request System is busy.
Feeder will be reactivated when the system is no
longer busy.
Wait until the message clears and continue.
E281 OCR was reset - restart batch Use the NEXT key to enter a starting Image
Address.
Rerun the batch.
E282 Comm buffer full - please wait System is busy.
Wait until the message clears and continue.