Kodak A-41069 - Manual (Page 33)

3 - 3 A-41069 January 1993
Unsuccessful calibration If the calibration is not successful, a message will appear in the Status
Display.
You may need to:
• Verify that you are using a clean, blank sheet of paper as a calibration
target.
• Verify that there is not a document already in the document path.
Refer to Troubleshooting - Clearing the document path.
• Clean the Imaging Guides. Refer to Maintenance - Cleaning the
imaging guides.
• Calibrate the Scanner again. If this calibration attempt fails, change
the lamps. Refer to Maintenance - Replacing the exposure lamps.
If the required action has been taken and another calibration attempt
fails, contact your local service representative.