Sun Microsystems Sun Fire V100 User Manual
Sun fire, V100 server user’s guide
Table of contents
Document Outline
- Contents
- Figures
- Tables
- Introducing the Sun Fire V100 Server
- Installing the Sun Fire V100 Server Into a Rack
- Communicating With the Server
- Powering On and Configuring the Sun Fire V100 Server
- Managing the Sun Fire V100 Server From the lom> Prompt
- Introduction to Lights-Out Management
- Using LOM Commands
- Powering On or Resetting the Server From the LOM Shell
- Monitoring the Server From the LOM Shell
- Setting Up LOM Privileges for Named Users
- Setting the LOM Configurable Variables
- Separating LOM From the Console on the Serial A/LOM Port
- Viewing Event Reports That LOM Sends to syslogd
- LOM Shell Command List
- Managing the Sun Fire V100 Server From the Solaris Prompt
- Interpreting the LEDs
- Removing and Replacing Components
- Reinstalling the Solaris Operating Environment
- Troubleshooting
- Diagnostic Tools
- Problems You Might Encounter
- Power On Failure
- Cannot Set Up a Console Connection to a Server
- No LOM Messages Displayed at the Terminal
- Cannot Display the lom> Prompt Using the #. Escape Sequence
- Problems Connecting to the Server Using a Handheld Device
- OpenBoot PROM Initialization Aborts and the Server Will Not Boot
- IDE Controller Failure
- Jumper Settings
- Frequently Asked Questions
- Physical and Environmental Specifications
- Configuring LOM Driver
- Index