Sun Microsystems Sun Fire V100 User Manual

Page 75

Chapter 5

Managing the Sun Fire V100 Server From the

lom>

Prompt

By default, all four areas of authorization are available to each named user you set
up. You can limit users to a particular area or areas of authorization by specifying
permissions for a named user.

▼

To Specify Permissions for a Named User

●

Type:

You can specify:

■

All four parameters (for example,

userperm cuar

)

This also makes all four areas available to the named user.

■

One, two, or three parameters
This makes only the parameter or parameters you specify available.

The parameters are:

■

This stands for “console permission”. It enables the named user to exit from the

lom>

prompt to the Solaris prompt (as long as the Serial A/LOM port is shared

between LOM and the console).

■

This stands for “user administration permission”. It enables the named user to
add and delete users and alter their areas of authorization by using the

userperm

command.

■

This stands for “administration permission”. It enables the named user to change
the LOM device’s configuration variables (see “Setting the LOM Configurable
Variables” on page 58).

■

This stands for “reset permission”. It enables the user you have named to reset
the server and to power it on and off using the LOM device.

■

Use this character to specify that no permissions are assigned.

lom> userperm

username

[c][u][a][r][-]