Sun Microsystems Sun Fire V100 - Manual (Page 122)

104 Sun Fire V100 Server User’s Guide • December 2001
■
If SunVTS software is not loaded, you will see the following error message:
Installing SunVTS
By default, SunVTS is not installed on the Sun Fire V100 server. SunVTS is
distributed via the Software Supplement for the Solaris Operating Environment CD. See
the Sun Hardware Platform Guide for details. The default directory to use when you
install SunVTS software is
/opt/SUNWvts.
Using SunVTS Software
To test a Sun Fire V100 server by running a SunVTS session from a workstation
using the SunVTS graphical user interface, follow the procedure below.
1. Use the xhost command to give the remote server access to the local display.
Type:
2. Remotely log in to the server as superuser or root.
3. Type:
Where local_hostname is the name of the workstation you are using.
Note – The directory /opt/SUNWvts/bin is the default directory for SunVTS
software. If you have the software installed in a different directory, use that path
instead.
When you start SunVTS software, the SunVTS kernel probes the test system devices
and displays the results on the Test Selection panel. There is an associated SunVTS
test for each hardware device on your system.
ERROR: information for “SUNWvts” was not found
# /usr/openwin/bin/xhost + remote_hostname
# cd /opt/SUNWvts/bin
# ./sunvts -display local_hostname :0