Sun Microsystems Sun Fire V100 User Manual
Page 111

Chapter 8
Removing and Replacing Components
93
■
If the server is already in use, see “To Change Components In a Sun Fire V100
Server That Is In Use” on page 88.
1. Place the unit on an ESD surface and attach an antistatic wrist strap (see
).
2. Remove the server’s top cover (see “To Remove the Top Cover” on page 89).
3. Remove the metal placeholder if your server has one (if it was configured with a
single hard disk drive, the second hard disk drive slot will have the placeholder
installed).
FIGURE 8-7
Removing the HDD Placeholder
4. Insert and align the new hard disk drive (see
a. Position HDD and slide onto the clips on the base of the server.
b. Press the handle into the two clips on the base of the server.