Sun Microsystems Sun Fire V100 - Manual (Page 33)

Chapter 2 Installing the Sun Fire V100 Server Into a Rack 15
8. Align the thumbscrews on the sides of the server with the slide mounts in the
rack (see FIGURE 2-8 ).
If necessary, readjust the slide mounts to align the server properly. The thumbscrews
need to be finger-tight.
FIGURE 2-8 Adjusting the Slide Mounts and Screwing the Server Into the Rack
9. Tighten the slide mounts in the rack if you have not fully secured them yet.
10. When the slide mounts are secure, use a screwdriver to tighten the thumbscrews
on the side of the server.
The server is now securely installed in the rack.
▼ To Fit the Cable Management Bracket
● Hook the bracket over the slide mounts at the rear of the server (see FIGURE 2-9 ).
You can use the loops in the bracket to secure the cables with cable ties.