Sun Microsystems Sun Fire V100 - Manual (Page 88)

70 Sun Fire V100 Server User’s Guide • December 2001
● To configure the LOM device to perform an automatic server restart (ASR) after a
lockup, you must enable the
Hardware reset option as well as the Watchdog
option.
For more information, see “Configuring Automatic Server Restart” on page 73.
▼ To View the Configuration of LOM
● To view the settings of all the configurable variables for the LOM device, type:
▼ To View All the Status Data Stored by LOM,
Plus Details of the Device’s Own Configuration
● Type:
Code example 6-1 gives sample output of this command.
# lom -c
LOMlite configuration settings:
serial escape character=#
serial event reporting=default
Event reporting level=fatal, warning & information
Serial security=enabled
Disable watchdog on break=disabled
Automatic return to console=disabled
alarm3 mode=watchdog
firmware version=3.0
firmware checksum=2983
product revision=0.0
product ID=Sun Fire 100
#
# lom -a
CODE EXAMPLE 6-1 Sample lom -a output
PSUs:
1 OK
Fans: