Serial connection settings – Sun Microsystems Sun Fire V100 User Manual
Page 39

Chapter 3
Communicating With the Server
21
FIGURE 3-1
Serial Port Pins 1 to 8
Serial Connection Settings
The settings you need to use for a serial connection are listed in
. If you
need to perform binary data transfers (that is, transfers of anything more than
simple ASCII character streams), use the B Serial port, as communication on the A
LOM port is subject to interruption by the LOM device (see “Introduction to Lights-
Out Management” on page 43).
TABLE 3-2
Settings for Connecting to the Serial A/LOM or Serial B Port
Parameter
Setting
Connector
Serial A/LOM or Serial B (use Serial B for binary data transfers)
Rate
9600 baud
Parity
No
Stop bits
1
Data bits
8
1
8
1
8
A LOM
B Serial