Sun Microsystems 3U - Manual (Page 85)

Chapter 6 Plumbing and Unplumbing SunATM Interfaces 63
A summary of the parameter options for the atmifconfig utility is provided in
TABLE 6-1 .
The following example shows the use of atmifconfig and the output of
ifconfig -a before and after the utility is run.
TABLE 6-1 Parameter Options for atmifconfig
Utility Interface Name Plumb Instruction
atmifconfig baN plumb
atmifconfig baN unplumb
atmifconfig laneN plumb
atmifconfig laneN unplumb
atmifconfig baN plumb-all
atmifconfig baN unplumb-all
# ifconfig -a
lo0: flags=849 mtu 8232
inet 127.0.0.1 netmask ff000000
ba0: flags=863 mtu 9180
inet 129.144.234.12 netmask ffffff00 broadcast 129.144.234.255
ether 8:0:20:84:e5:31
lane0: flags=863 mtu 1500
inet 129.144.161.12 netmask ffffff00 broadcast 129.144.161.255
ether 8:0:20:84:e5:31
# atmifconfig ba0 unplumb
# ifconfig -a
lo0: flags=849 mtu 8232
inet 127.0.0.1 netmask ff000000
lane0: flags=863 mtu 1500
inet 129.144.161.12 netmask ffffff00 broadcast 129.144.161.255
ether 8:0:20:84:e5:31
# atmifconfig lane0 unplumb
NOTICE: lane0: leaving ELAN
# ifconfig -a
lo0: flags=849 mtu 8232
inet 127.0.0.1 netmask ff000000
# atmifconfig ba0 plumb-all
q93b on ba0: Data Link Up
Configuring ATM interfaces: ba0
Configuring ATM LAN Emulation interfaces: lane0