Sun Microsystems 3U - Manual (Page 103)

81
A P P E N D I X
B
Testing the Adapter
This appendix describes how to test the adapter using either the SunVTS diagnostic
application or the onboard FCode self-test.
This appendix contains the following sections:
■ “Using the SunVTS Diagnostic Software” on page 81
■ “Using the OpenBoot PROM FCode Self-Test” on page 82
Using the SunVTS Diagnostic Software
The SunVTS software executes multiple diagnostic hardware tests from a single user
interface. It is used to verify the configuration and functionality of most hardware
controllers and devices. The SunVTS software operates primarily from a user
interface that enables you to set test parameters while the program performs
diagnostic test operations.
The following SunVTS tests can be used to test the SunATM adapter.
Note – Do not run nettest and atmtest at the same time.
TABLE B-1 SunVTS Tests
SunVTS Test Description
nettest Checks all the networking interfaces on a system.
atmtest Provides functional test coverage of SunATM adapters. The
atmtest provides better fault isolation as compared to nettest .