Sun Microsystems 3U - Manual (Page 45)

23
C H A P T E R
4
Configuring the SunATM Interfaces
After installing the adapter in your system, you must configure the SunATM
software before you can use the new interface. This chapter describes how to
configure the software using the
atmadmin configuration program. This program
enables you to configure the software parameters through an interactive command-
line interface.
This chapter contains the following sections:
■ “Using the atmadmin Configuration Program” on page 24
■
“Starting the atmadmin Configuration Program” on page 24
■
“atmadmin Main Menu” on page 25
■
“atmadmin Navigation Commands” on page 25
■
“System Parameter Group Menu” on page 26
■
“Interface Configuration Menu” on page 27
■ “atmadmin Parameter Groups” on page 28
■
“Physical-Layer Parameter Group” on page 30
■
“Signalling Parameter Group” on page 31
■
“ILMI Parameter Group” on page 32
■
“Classical IP Parameter Group” on page 32
■
“LAN Emulation Parameter Group” on page 36
Note – After configuring the SunATM interface, you must activate (plumb) it using
the atmifconfig utility. See Chapter 6 for more information.