Interface configuration menu, Atmadmin and the sunatm configuration files, Atmadmin – Sun Microsystems 3U User Manual

Page 49

Chapter 4

Configuring the SunATM Interfaces

Interface Configuration Menu

Once you select a SunATM interface, you will see the

atmadmin

Interface

Configuration menu. From this menu you can proceed to the interface parameter
group submenus, which are described in “atmadmin Parameter Groups” on page 28.
You can use these sub-menus to change the SunATM interface configuration
parameters.

atmadmin

and the SunATM Configuration Files

The

atmadmin

program first attempts to read the current configuration

information from the following directories

■

/etc/opt/SUNWconn/atm/atmconfig

■

/etc/opt/SUNWconn/atm/aarconfig

■

/etc/opt/SUNWconn/atm/laneconfig

If no configuration information is found, or if the files do not exist, the default
values listed in

TABLE 4-2

are applied to the installed interfaces.

Caution –

When saving configuration information,

atmadmin

overwrites the

existing SunATM configuration files in the

/etc/opt/SUNWconn/atm

directory.

Therefore, any comments or other changes you manually made to the files will be
lost.

Modifying ba0

[Y] Physical Layer

[U] UNI Signalling

[I] ILMI Address Registration

[C] Classical IP

[L] LAN Emulation

[P] Previous Menu

[M] Main Menu

[X] Exit

[?] Help

Enter selection: