Sun Microsystems 3U - Manual (Page 136)

114 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001
aarsetup: waiting for ilmid to provide prefix
lanesetup: waiting for ilmid to provide prefix
In some cases, the address registration process may take several minutes. If so,
aarsetup or lanesetup prints out this message saying that it cannot complete
until address registration completes. If the messages continue for more than a
minute or two, verify your connection to the switch, and that the switch and
interface are both supporting ILMI.
undefined variable
You used a variable in a configuration file without using a set statement to assign
the value. Add a
set statement, or correct the variable name, and run aarsetup
or lanesetup again. See “Using Variables in the aarconfig File” on page 47, and
“Using Variables in the laneconfig File” on page 56, for more information.
variable already defined
You tried to set a variable that had been previously set in the same configuration
file. Remove the second assignment and run
aarsetup or lanesetup again.
variable name ill-formed
You created a variable in /etc/opt/SUNWconn/atm/aarconfig or /etc/opt/
SUNWconn/atm/laneconfig that was syntactically invalid. Variable names are a
combination of letters, digits, and underscores ( _ ). Choose a conforming variable
name and run aarsetup or lanesetup again.
variable name too long
You created a variable in /etc/opt/SUNWconn/atm/aarconfig or /etc/opt/
SUNWconn/atm/laneconfig with a name that is greater than the maximum
length (32 characters). Choose a variable name shorter than 32 characters and run
aarsetup or lanesetup again.
variable value too long
You assigned a value longer than the maximum value length of 128 characters to
a variable in a configuration file. If you want a longer value, use a combination of
variable names, with each value less than 128 characters. After correcting the
variable value lengths, run
aarsetup or lanesetup again.
ifname:cannot join ELAN (frame size too large; please use
a different ELAN and rerun lanesetup)
The largest MTU size supported by the SunATM software is 9 kilobytes. If the
LAN Emulation Services try to set a size larger than 9 Kbytes, the SunATM client
cannot join the emulated LAN. Reset your LAN Emulation services to use an
MTU size less than or equal to 9 Kbytes, and rerun
lanesetup to join the
emulated LAN.