Datasheet – SMSC LAN91C111 User Manual
Page 77
10/100 Non-PCI Ethernet Single Chip MAC + PHY
Datasheet
SMSC LAN91C111 REV C
77
Revision 1.91 (08-18-08)
DATASHEET
NP - Next Page
A ‘1’ indicates the PHY wishes to exchange Next Page information.
ACK - Acknowledge
It is used by the Auto-negotiation function to indicate that a device has successfully received its Link
Partner’s Link code Word.
RF - Remote Fault
When set, an advertisement frame will be sent with the corresponding bit set. This in turn will cause
the PHY receiving it to set the Remote Fault bit in its Status register
T4 - 100BASE-T4
A '1' indicates the PHY is capable of 100BASE-T4
TX_FDX - 100BASE-TX Full Duplex Capable
A '1' indicates the PHY is capable of 100BASE-TX Full Duplex
TX_HDX - 100BASE-TX Half Duplex Capable
A '1' indicates the PHY is capable of 100BASE-TX Half Duplex
10_FDX - 10BASE-T Full Duplex Capable
A '1' indicates the PHY is capable of 10BASE-T Full Duplex
10_HDX - 10BASE-T Half Duplex Capable
A '1' indicates the PHY is capable of 10BASE-T Half Duplex
The management entity sets the value of this field prior to AutoNegotiation.
‘1’ in these bit indicates that the mode of operation that corresponds to these will be acceptable to be
auto-negotiated to. Only modes supported by the PHY can be set.
CSMA
A '1' indicates the PHY is capable of 802.3 CSMA Operation
9.5
Register 5. Auto-Negotiation Remote End Capability Register
The bit definitions are analogous to the Auto Negotiation Advertisement Register.
NP
ACK
RF
Reserved
Reserved
Reserved
T4
TX_FDX
R
R
R
R
R
R
R
R
0
0
0
0
0
0
0
0
TX_HDX
10_FDX
10_HDX
Reserved
Reserved
Reserved
Reserved
CSMA
R
R
R
R
R
R
R
R
0
0
0
0
0
0
0
0