SMSC LAN91C111 - Manual (Page 75)

10/100 Non-PCI Ethernet Single Chip MAC + PHY
Datasheet
SMSC LAN91C111 REV C 75 Revision 1.91 (08-18-08)
DATASHEET
DPLX - Duplex mode
When Auto Negotiation is disabled this bit can be used to manually select the link duplex state. Writing
a ‘1’ to this bit selects full duplex while a ‘0’ selects half duplex.
When Auto-Negotiation is enabled reading or writing this bit has no effect.
COLTST - Collision test
Setting a ‘1’ allows for testing of the MII COL signal. ‘0’ allows normal operation.
Reserved:Reserved, Must be 0 for Proper Operation
9.2 Register 1. Status Register
CAP_T4 - 100BASE-T4 Capable
‘1’ Indicates 100Base-T4 capable PHY, ‘0’ not capable.
CAP_TXF - 100BASE-TX Full Duplex Capable
‘1’ Indicates 100Base-X full duplex capable PHY, ‘0’ not capable.
CAP_TXH - 100BASE-TX Half Duplex Capable
‘1’ Indicates 100Base-X alf duplex capable PHY, ‘0’ not capable.
CAP_TF - 10BASE-T Full Duplex Capable
‘1’ Indicates 10Mbps full duplex capable PHY, ‘0’ not capable.
CAP_TH - 10BASE-T Half Duplex Capable
‘1’ Indicates 10Mbps half duplex capable PHY, ‘0’ not capable.
Reserved:Reserved, Must be 0 for Proper Operation.
CAP_SUPR - MI Preamble Suppression Capable
‘1’ indicates the PHY is able to receive management frames even if not preceded by a preamble. ‘0’
when it is not able.
ANEG_ACK - Auto-Negotiation Acknowledgment
When read as ‘1’ indicate ANEG has been completed and that contents in registers 4,5,6 and 7 are
valid. ‘0’ means ANEG has not completed and contents in registers 4,5,6 and 7 are meaningless. The
PHY returns zero if ANEG is disabled.
CAP_T4 CAP_TXF CAP_TXH CAP_TF CAP_TH Reserved Reserved. Reserved
R R R R R R R R
0 1 1 1 1 0 0 0
Reserved CAP_SUPR ANEG_ACK REM_FLT CAP_ANEG LINK JAB EXREG
R R R R, LH R R, LL R, LH R
0 0 0 0 1 0 0 1