Siemens SpeedStream SS2524 - Manual (Page 9)

Introduction
5
Rear Panel
Figure 3 Rear Panel
Power port Connect the supplied power cord here.
Aerial Antenna Best results are usually obtained with the antenna in a vertical posi-
tion.
Reset Button This button has two (2) functions:
•
Reboot. When pressed and released, the SpeedStream Powerline
Wireless Router will reboot (restart).
•
Reset to Factory Defaults. This button can also be used to clear
ALL data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off the router
2. Hold the Reset Button down while you Power On the router.
3. Continue holding the Reset Button until the Status (Red) LED
blinks TWICE.
4. Release the Reset Button.
The factory default configuration has now been restored, and the
Router is ready for use.
WAN port
(10/100BaseT) Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard CAT5 UTP
LAN cable.
10/100BaseT
LAN connectors Use standard LAN cables (RJ45 connectors) to connect to your PCs.
Both 10BaseT and 100BaseT connections can be used simultaneously.
All 4 LAN ports are capable of being connected to another hub
with a straight-through cable. Any port will automatically act as
an “uplink” port when required.
Warning!
The case contains no user-serviceable components. Only qualified service staff should open
the case.