Siemens SpeedStream SS2524 User Manual

Page 50

SpeedStream Powerline Wireless Router User Guide

•

The most common messages are listed in the table below.

•

The "Clear Log" button will restart the Log, while the
Refresh button will update the messages shown on screen.

Buttons

Connect

If not connected, establish a connection to your ISP.

Disconnect

If connected to your ISP, hang up the connection.

Clear Log

Delete all data currently in the Log. This will make it easier to
read new messages.

Refresh

Update the data on screen.

Connection Log Messages

Message

Description

Connect on Demand

Connection attempt has been triggered by the "Connect
automatically, as required" setting.

Manual connection

Connection attempt started by the "Connect" button.

Reset physical connection

Preparing line for connection attempt.

Connecting to remote
server

Attempting to connect to the ISP's server.

Remote Server located

ISP's Server has responded to connection attempt.

Start PPP

Attempting to login to ISP's Server and establish a PPP
connection.

PPP up successfully

Able to login to ISP's Server and establish a PPP connection.

Idle time-out reached

The connection has been idle for the time period specified in
the "Idle Time-out" field. The connection will now be termi-
nated.

Disconnecting

The current connection is being terminated, due to either the
"Idle Time-out" above, or "Disconnect" button being clicked.

Error: Remote Server not
found

ISP's Server did not respond. This could be a Server problem,
or a problem with the link to the Server.

Error: PPP Connection
failed

Unable to establish a PPP connection with the ISP's Server.
This could be a login problem (name or password) or a Server
problem.

Error: Connection to
Server lost

The existing connection has been lost. This could be caused
by a power failure, a link failure, or Server failure.

Error: Invalid or unknown
packet type

The data received from the ISP's Server could not be proc-
essed. This could be caused by data corruption (from a bad
link), or the Server using a protocol that is not supported by
this device.