Siemens SpeedStream SS2524 - Manual (Page 34)

SpeedStream Powerline Wireless Router User Guide
30
Figure 17: Windows NT4.0 - IP Address
3. Select the network card for your LAN.
4. Select the appropriate radio button - Obtain an IP address from a DHCP Server or
Specify an IP Address, as explained below.
Obtain an IP address from a DHCP Server
This is the default Windows setting. Using this method is recommended. By default, the
SpeedStream Powerline Wireless Router will act as a DHCP Server.
Restart your PC to ensure it obtains an IP Address from the SpeedStream Powerline Wireless
Router.
Specify an IP Address
If your PC is already configured, check with your network administrator before making the
following changes.
1. The Default Gateway must be set to the IP address of the SpeedStream Powerline Wire-
less Router. To set this:
•
Click the Advanced button on the screen above.
•
On the following screen, click the Add button in the Gateways panel, and enter the
SpeedStream Powerline Wireless Router's IP address, as shown in Figure 18 below.
•
If necessary, use the Up button to make the SpeedStream Powerline Wireless Router
the first entry in the Gateways list.