Siemens SpeedStream SS2524 - Manual (Page 11)

Installation
7
2. Use Cat 5 Ethernet cable(s) to connect PC(s) to the hub ports on the SpeedStream Power-
line Wireless Router. If desired, any port can also to be connected to a standard port on
another hub.
3. Connect your DSL/Cable modem to the WAN port on the SpeedStream Powerline Wire-
less Router using the Ethernet cable supplied with your DSL/Cable modem. If no cable
was supplied with your modem, use a straight-through CAT 5 Ethernet cable.
4. Attach the wireless antenna to the connector provided on the back of the router. Secure
the antenna by turning the grooved or ridged ring on the antenna until snug (Do not over
tighten).
5. Connect the supplied power cord to the SpeedStream Powerline Wireless Router.
The SpeedStream Powerline Wireless Router has built-in
surge protection. It is not recommended to plug the
router into a power strip, surge protector or UPS as the
Powerline connection speed and quality will be affected.
6. Check the LEDs:
•
The Status LED should flash, then turn Off.
•
The Power, WAN, Powerline and Wireless LEDs should be ON.
•
For each active LAN (PC) connection, the LAN Link/Act LED should be ON.
For more information, refer to Front Panel LEDs in Chapter 1.